FabulaTech Forum
        (http://www.network-serial-port.com/forum)
      

        Serial Port Solution >> Virtual Serial Port Kit >> Break Line simulation?
        
(Message started by: lmpombo on Mar 26th, 2007, 1:27am)
Title: Break Line simulation?
Post by lmpombo on Mar 26th, 2007, 1:27am
Hi everyone,

  I really like this software. I was trying to debug a serial communication program I made and used to test it. Everything was good until I had to test timeouts by simulating a line break or cable removal. Is it possible to do this with this program? I have searched everywhere but could not do it.
I like this program best because it is better in terms of pin parameters.
Please tell me if it is possible to simulate line breaks with this.

Thank you very much.
Kind regards,

lmpombo
Title: Re: Break Line simulation?
Post by Andrew on Mar 26th, 2007, 1:46am
Hi,
Thank you for your interest in our software and for good words about it. Unfortunately there is no feature that emulates line breaking. May be you could test timeouts on one side by closing application on another side?
Thank you.
Title: Re: Break Line simulation?
Post by lmpombo on Mar 26th, 2007, 9:52am
Well, I did that for the timeout tests already. But the problem is I have to test something like breaking the line and then bring it back up so that I can test the resume transfer functions.

Any ideas?

Thank you very much.

Kind regards,

lmpombo